The in-line atomizer is a chamber which is used to mix the lubricant and
air into a atomized spray

This nozzle is designed to point directly at the teeth of the band saw blade. Designed to apply an even coat of lubricant to a band saw blade.

Discontinued replaced by the 9878

This new design for 2008 is now more compact making it easier to install and the internal atomization chamber produces a better more even spray pattern than previous versions.

More Information

This new design for 2008 is now more compact making it easier to install and the internal atomization chamber produces a better more even spray pattern than previous versions.

More Information

(two inputs three Outputs) requires a two nozzle applicator.

Larger band saw blades need the additional lube of a second pump. This nozzle gives you the secure installation for larger saws.

Remove chips with this independent flow control blow-off nozzle. Install before the filter/regulator on any Accu-Lube applicator. Use air to blow chips away from the cutting tool and allow the fluid air/oil nozzle deliver the lubricant to the tool.

hose (Threaded)

Disconnect and reconnect the coaxial air/oil hose assembly with this simple clever fitting assembly.

This aluminum block is drilled through and tapped 1/4″ NPT at both ends to hold lock line nozzles and hose barbs as required.
One mounting hole tapped to 12-24 for secure mounting.

This aluminum block is drilled through and tapped 1/8″ NPT at both ends.
Two mounting holes tapped 10-32 for secure mounting.

Hold a nozzle in place with this slip fitting.
Just tap a hole 1/8″NPT nozzle slides through and clamps down.