Accu-Lube Electric Solenoids 200 Series

Install this 200 series electric on/off air flow control valve
in-line any 1/4” compressed air supply where maximum air flow is
required. Although the same 1/4” NPT in-line connection, this larger
valve allows more SCFM through than the 100 series. Replacement for an
Accu-Lube three or four nozzle applicator or use to automate the air
supply to a manual applicator with up to four nozzles. Also used to
automate the flow to a bank of external air blow off nozzles for
removing chips from the work area. Two coils cover 4 different voltage .

Although dirty or wet air supply can cause a solenoid valve to stop
functioning, most of the time all you need is a new coil when the
solenoid fails. Simple to replace in the field with only two screws in
the front, choose the correct voltage.

Pressure range :

Lubrication :

Filtration :

Temperature range :

Flow (at 6 bar ?P=1bar) :

Leak rate :

Coil :

Voltage range :

Protection:

Power :

Response times :

Vacuum to 150 PSI

Not required, if used select a medium aniline point lubricant (between 180°F and 210°F)

40 ?

0°F to 140°F (-18°C to 60°C)

0.5 Cv

50 cm3/min

General purpose class A, continuous duty, encapsulated

-15% to +10% of nominal voltage

Consult factory (MAC)

~ Inrush : 33 VA Holding : 19.7 VA = 1 to 24 W

24 VDC (8.5 W)    Energize : 15 ms
De-energize : 5 ms

120/60
Energize : 3-8 ms     De-energize : 3-13 ms