Band Saw Nozzle (Complete Assembly: Nozzle, Tip and Mount), Part # 9692

Band Saw Nozzle (Complete Assembly: Nozzle, Tip and
Mount), Part # 9692

This nozzle is designed to
point directly at the teeth of the band saw blade.  Specifically
designed for the thin kerf of a band saw blade this nozzle when
connected to a single Accu-Lube pump applicator applies an even coat of
lubricant to three sides of the blade; the teeth, and both sides.

Mount the nozzle up inside the the saw either through the back of the
saw or through the blade guard depending on the orientation of the
blade.  Drill a 1.25" hole directly over the center of the blade. 
Mount the nozzle block over the hole centering the nozzle over the teeth
of the blade.  Telescope the nozzle through the mounting block
locking it secure about 3/4" back from the teeth of the blade buy
tightening the socket screws on the side of the mounting block.